Sensor Connection Terminal Blocks from ASI Simplify Sensor Wiring
3-Wire Sensor Terminal Blocks
The TLS.2/GR is the most cost effective, easy-to-install 3-wire sensor terminal block on the market. The TLS sensor terminal block comes equipped with jumpers on levels one and two, where you make the power connections for each sensor. This is called the lock system. The top level is for the signal connection of the sensor to the controller. When you slide the TLS sensor terminal block to the next sensor terminal block or to the power distribution 3 level terminal block TLD.2 you simply slide the "lock system" fork under the screw on the adjacent block, tighten it down and your power or common connection is made. Power for the sensors is brought into the TLD.2 3 level terminal block and then distributed to the TLS sensor blocks.
The TLS.2 sensor termination terminal block is also available with an LED between the lower or intermediate level and upper level for NPN or PNP sensors in order to give a visual indication of operation right at the terminal block for ease of testing and system troubleshooting.
TLS.2/U Cat. No. TL110 (with green LED between upper and lower levels)
TLS.2/T Cat. No. TL120 (with green LED between upper and intermediate levels)
The TLD.2 is a 3-level feed through terminal block that is used in high density wiring applications. It is also used in combination with the TLS.2, a 3-wire sensor termination terminal block for the power connections and distribution. At only 6.2mm wide, this block will terminate 6 wires in 1/3 the space of typical terminal blocks. As a power distribution terminal block the TLD.2 mounts next to the TLS.2 sensor block and accepts the lock jumper system for connection of the negative and positive circuits to sensors.
ASI's broad range of marking products will save you both Time and Money. They include terminal block labels, wire markers, name plates, and much more Learn More...
View Associated Products Below to Complete Your Project
Catalog No. / Description
Screw Clamp Connection 3-Level Sensor/actuator DIN Rail Mount Terminal Block With Feed Through
Additional Accessories shown on datasheet
3-Level sensor/actuator DIN rail mount terminal blocks saves space and wiring
Upper level is a feed- through connection for the signal
Middle level connects a power source to the actuator
Lower level connects to ground
UKJ series screw frame clamp terminal blocks fulfill all requirements of IEC60947-7-1,IEC60947-7-2, GB14048.7,GB14048.8 and JB/T9659.1 standards
Type UKJ-DOK1.5RD/O-M, Screw clamp 3 level DIN rail mount terminal block with upper level feed through, middle level supplies power to acutuator and lower level is ground, with Red LED for optical signaling, 24-14 AWG, gray
$12.95 / Block
50 $12.95 Each
250 $11.51 Each
500 $10.36 Each
Need More >> Call For Quote
Customers using ASI Sensor Connection Also Saved Time and Money with:
The most practical component that you will ever use if sensors are in your equipment. You can easily convert from PNP to NPN or NPN to PNP so you are never stuck without a sensor to match your controller. The best feature is the economical price!