If you ever have to add a dropping resistor, a blocking diode or surge protection, such as a varistor, then the electronic component spring clamp terminal blocks can make that job easy. The need to add a component in circuit wiring is so popular that we even offer this easy to wire terminal block with 1N4007 diodes already in place, see below.
The spring clamp electronic component terminal block is a double level terminal block that is available in a thin version, only 4.2mm wide and in a 5.2mm version for larger components. If that is not wide enough check out some of the other component options in the ASI PCB holder section.
These blocks feature the following customer friendly designs:
Spring clamp wire terminations for quick and reliable wiring
Four independent wiring points with component wire connection points
Each wire point and level accepts the patented "Easy Bridge" push-in jumpers which can allow for easy connection to adjacent terminal blocks
Labels can be inserted at each wiring point to properly identify the circuit
Diode installed versions are now available
Custom Terminal Blocks
In addition to these features the customer can contact ASI to have a custom terminal block manufactured housing components or circuits designed by your engineers. This allows you to order and receive a terminal block with component ready immediately for installation. -
ASI's broad range of marking products will save you both Time and Money. They include terminal block labels, wire markers, name plates, and much more Learn More...
Catalog No. / Description
Spring Clamp Connection 2-Level Component Holder DIN Rail Mounted Terminal Block
Additional Accessories shown on the Datasheet
Space saving 4.2mm deep 2-level terminal block with spring connections rated at 26 - 14 AWG and 15 amps, 600 volts
Accepts the low-cost push in jumpers, "easy bridge" for connecting adjacent circuits
2-level terminal blocks use spring clamp connections
Push-In staggered jumper capable on each level
Offers 4 independent connection points where internally the customer can solder components such as diodes, resistors or others which will fit in the cavity of the terminal block.