The TLS.2 is the most cost effective, easy-to-install 3-wire sensor terminal block on the market.
The TLS sensor terminal block comes equipped with built-in jumpers on the bottom and middle levels, where you make the power connections for each sensor. This is called the "Lock System". The top pass-through level is for the signal connection of the sensor to the controller.
Slide a TLS sensor terminal block against another sensor terminal block or against a 3-level TLD.2 power distribution terminal block, sliding the "Lock System" fork under the screw on the adjacent block. Tighten it down and your power and/or common connection is completed. Power for your sensors is brought in using a 3-level TLD.2 terminal block and then distributed to the TLS sensor blocks via the built-in jumpers.
The TLS.2 sensor termination terminal block is also available with LED indication between the upper level and either the lower or intermediate level for NPN or PNP sensors, giving visual indication of operation right on the terminal block, for ease of testing and system troubleshooting.
The TLD.2 is a 3-level feed-through terminal block that is used in high density wiring applications, along with the 3-wire TLS.2 sensor termination terminal block for the power connections and distribution. Only 6.2mm wide, you can terminate 6 wires in only 1/3 the space required by other terminal blocks. As a power distribution terminal block it mounts next to the sensor block and accepts the lock jumper system for connection of the negative and positive circuits to sensors.-
ASI's broad range of marking products will save you both Time and Money. They include terminal block labels, wire markers, name plates, and much more Learn More...
View Associated Products Below to Complete Your Project
Catalog No. / Description
Screw Clamp Connection 3-Level Sensor/actuator DIN Rail Mount Terminal Block With Feed Through
Additional Accessories shown on datasheet
3-Level sensor/actuator DIN rail mount terminal blocks saves space and wiring
Upper level is a feed- through connection for the signal
Middle level connects a power source to the actuator
Lower level connects to ground
UKJ series screw frame clamp terminal blocks fulfill all requirements of IEC60947-7-1,IEC60947-7-2, GB14048.7,GB14048.8 and JB/T9659.1 standards
Type UKJ-DOK1.5RD/O-M, Screw clamp 3 level DIN rail mount terminal block with upper level feed through, middle level supplies power to acutuator and lower level is ground, with Red LED for optical signaling, 24-14 AWG, gray
$12.95 / Block
50 $12.95 Each
250 $11.51 Each
500 $10.36 Each
Need More >> Call For Quote
Customers using ASI Sensor Connection Also Saved Time and Money with:
The most practical component that you will ever use if sensors are in your equipment. You can easily convert from PNP to NPN or NPN to PNP so you are never stuck without a sensor to match your controller. The best feature is the economical price!
Monday-Friday: 8:30am - 5:00pm ET (Orders Placed by 4:00pm ET will Ship Same Day)
Engineering Disclaimer: On all cross-references it is the customer's responsibility to confirm that the suggested equivalent meets all requirements of the intended application, as there may be slight differences.
Automation Systems Interconnect, Inc. 4700 Westport Drive, Suite 500
| Mechanicsburg, PA 17055 REMIT-TO: P.O. Box 1340 | Mechanicsburg, PA 17055
Toll-Free: 877-650-5160 | 717-249-5581 | 717-249-5542 Fax firstname.lastname@example.org | www.asi-ez.com