Standard Single Level Spring Clamp Terminal Blocks
The ASI standard HMM line of spring terminals is available in models as thin as the 4.2mm thick HMM.1 which is rated for 15 amps, up to the HMM.16 that carries a 76 amp rating.
Features That Make The Difference
The clamping system in each terminal block is protected from over-stressing the contact with a molded-in backstop in the terminal block housing.
The single level spring clamp terminal blocks can be labeled both on the side and the top of the terminal block for easy visual identification of the circuit.
They are designed to accept the patented "Easy Bridge" jumper system which allows the customer to create a wide range of circuit configurations with placement in one or two slots. When the PTC, "Easy Bridge" jumper is inserted into the terminal block it is fully insulated.
Ferrules are typically used on the ends of wires especially when spring clamp terminal blocks are used. This practice began in Europe and has now become commonplace in the USA. ASI will save you additional money on your application with our wide range of low-cost ferrules and crimping tools.
The bench-top DIN rail cutter from ASI quickly cuts all major types of DIN rail, comes with a steel rule measuring device for setting up multiple cuts of the same length and features a hardened steel cutting die for long life. It cuts the DIN rail clean so burrs are eliminated and the long actuation lever insures that anyone can cut the DIN rail. It is half the price of comparable DIN rail cutters now on the market.